This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
wlbrdkmtk [2022/07/06 16:18] steve |
wlbrdkmtk [2022/08/22 13:01] (current) steve Added format chars so git URLs and '--' are shown correctly |
||
---|---|---|---|
Line 9: | Line 9: | ||
- //cd < | - //cd < | ||
- | - //repo init -u https:// | + | - //repo init -u %%https:// |
- | - //repo sync -c -j `nproc` --no-clone-bundle// | + | - //repo sync -c -j `nproc` |
- //repo forall -c 'if [ -e .gitattributes ];then git lfs pull; | - //repo forall -c 'if [ -e .gitattributes ];then git lfs pull; | ||
Line 16: | Line 16: | ||
- //cd < | - //cd < | ||
- | - //repo init -u https:// | + | - //repo init -u %%https:// |
- | - //repo sync --no-clone-bundle// | + | - //repo sync %%--no-clone-bundle%%// |
- Copy the meta layer directories from < | - Copy the meta layer directories from < | ||
- //git clone git@github.com: | - //git clone git@github.com: | ||
- //cd meta-dtvkit-mtk// | - //cd meta-dtvkit-mtk// | ||
- | - //git checkout | + | - //git checkout |
- //cd ..// | - //cd ..// | ||
Line 29: | Line 29: | ||
* Select " | * Select " | ||
* //bitbake lib32-rdk-generic-hybrid-dtv-image// | * //bitbake lib32-rdk-generic-hybrid-dtv-image// | ||
+ | |||
+ | == Flashing == | ||
+ | When the build has completed successfully, | ||
+ | |||
+ | Now proceed with the following steps: | ||
+ | |||
+ | * Connect the serial adapter to the STB as shown here: | ||
+ | {{ : | ||
+ | * Use a serial communication program to connect to the serial and use the following settings: 115200 bps, 8 data bits, 1 stop bit, no parity, no hardware flow control. | ||
+ | * Power on the STB and within the first 3 seconds press any key (e.g. spacebar) to interrupt the boot process. You should now be at the a command prompt showing: “// | ||
+ | * Insert the USB stick into either of the 2 USB ports on the side of the STB. | ||
+ | * If the USB stick is inserted into the USB towards the front of the STB, enter //usb start 2// at the command prompt. | ||
+ | * If the USB stick is inserted into the USB towards the rear of the STB, enter //usb start 0// at the command prompt. | ||
+ | * Completion of either of the above commands should result in “1 Storage Device(s) found” being shown on the console. | ||
+ | * To start the update, enter //udstar// at the command prompt. | ||
+ | * The update will take less than 2 minutes after which the box will boot into the newly installed image. | ||